G5 Voodoo Pro

Click here for more technical information (includes downloads for the Quickstart Guide and I/O table)

Inputs/Outputs

• Control any engine with 2 cylinders, all the way up to 12 cylinders, thanks to:

  • 12 injector pins

  • 8 ignition pins

  • 4 injector/ignition dual role pins

• Access up to 30 auxilary pins (when setup for a 4-cylinder sequential engine):

  • 8 dedicated auxiliary pins

  • 4 shared e-throttle/H-Bridge pins

  • 2 shared wideband heater pins

  • Up to 16 from spare injector and ignition drives

• Any unused injector/ignition pins can be used as an auxiliary pin

• All ignition and auxiliary pins are back feed protected.

• 14 analog inputs

• 10 digital inputs

• 4 temperature inputs

• Dual knock inputs

• 2 trigger inputs

• Dedicated ignition switch pin

• 2 x internal wideband lambda controllers

• Dual e-throttle, with internal solid state throttle disconnect relays

• 5v sensor supply

• CAN 1 input now supported via CAN connector

Communications

• USB-C (cable included)

• Connect directly to the ECU via built-in Wifi Access Point, or add it to an existing network (Antenna Included)

• Dual CAN (CAN 1 on CAN connector, CAN 2 on header E)

• GPS (antenna included)

Size & Weight

• Length: 177.1mm (6.97 inches)

• Width: 137.3mm (5.40 inches)

• Min side height: 15.5mm (0.61 inches)

• Max side height: 40.2mm (1.58 inches)

• Weight: 795g (28 ounces)

Connectivity

The G5 Voodoo Pro supports the following comms standards:

• USB-C

• Wi-Fi

• CAN

• GPS

The G5 Voodoo Pro uses the Super Seal A, B & E plugs.

It is now possible to connect to your ECU using a standard USB-C cable, or alternatively by using WiFi.

You can now access CANBUS 2 via its own dedicated pins in Header E freeing up two Digital Inputs.

GPS connectivity can be initialised by simply adding a GPS antenna.